• Копировщик для эмулятора 35160Wx, 35128Wx (пайка)

Копировщик для эмулятора 35160Wx, 35128Wx (пайка)

  • Модель: Copier for emu-35160Wx, 35128Wx (soldering)
  • $60.00
В наявності

35160Wx/35128Wx Copier - is the pcb for easy and standalone copying of all data from original EEPROM 35160, 160D0Wx, 35128Wx to the emulator chip named "emu-35160" or "emu-35128".

These emulator chips "emu-35160", "emu-35128" are the special devices, has the ability to copy data from the source chip. This emul.chip make this process of copying easiest and faster.

Soldering: with soldering iron or hot-air soldering station (220*, max.230*). On the pcb of dashboard, you need to change the solder to the usual (not Pb-free) because it have a lower temperature of melting.

Desoldering: with hot-air soldering station (220*, max.230*)! The pcb of emulator has a very small pads, they may tear off easily.

After soldering (or simple applying by pressing) of source EEPROM and chip "emu-35160" or "emu-35128" on this copier pcb, apply the power. The led on the copier pcb will show the next states of process:

- Lights ~3sec (~15sec for 35128), then light off. Means all is ok, all data was copied, you may unmount the devices and use them.

- Flashes shortly, period 0.5sec. Means that the "emu-35160" or "emu-35128" pcb "don't see" the source EEPROM.

  Please check the orientation of source EEPROM, soldering of all pins of both devices on the copier pcb.

- Led is not lights at all. Check the power applied to the copier pcb, polarity etc. Check the orientation of emulator device mounted.

 

Orientation of "emu-35160" or "emu-35128" chips:

Near of pin 1 is placed small ceramic capacitor, close to pin 5 placed small black resistor 100 ohm, 0402 size.

The emulators sold since 10.2016 have a laser marking "160" or "128" with dot near of pin 1.

Difference between Emu35160 and Emu35128:
35160: under the glue you can see the chip 3х3mm, smallest than emulator pcb. Power 3.3...5V.
35128: under the glue you can see the chip 4х4mm, size is approx. of emulator pcb size. Power 3.3V only.

 

Power of Copier pcb:  3.3v to 12.9v


Написати відгук

Увага: HTML розмітка не підтримується. Використовуйте звичайний текст.
    Погано           Добре
Введіть свій номер і ми вам невдовзі передзвонимо