TOYOTA - LEXUS ECU FLASHER

SUPPORT OBD NEW MODELS >2015 READ/ WRITE !!!

DO NOT CONNECT

external 12V power for OBD mode!!!

USB ONLY !!!

The Toyota Flasher, a joint project by Autokey and PCMflash is a multipurpose programmer for Denso and Fujitsu Ten ECUs with NEC processors installed in TOYOTA, LEXUS and SCION vehicles with petrol and diesel engines through JTAG interface. It is a unique solution in the chip tuning world. It covers almost all the models beginning from 2003-2004. It can read, flash, clear, verificate internal flash memory of microcontrollers if connected to the appropriate connector on the ECU circuit board. Now also writing through OBD-II via CAN-bus is available.

Supported ECUs:

All ECUs with the following processors NEC 7F00XX: 76F0038, 7F0038A, 76F0039, 76F0039A, 76F0040, 76F0040A, 76F0070 BGA, 76F0085 BGA. These processors were introduced at the beginning of CAN support and as a rule with coachwork change.

OYOTA DENSO ENGINE CONTROL MODULE

based on NEC 7F00XX series MCU

 

76F0038

7F0038A

76F0039

76F0039A

76F0040

76F0040A

76F0070 BGA

76F0085 BGA

 

 

saving in normal mode

without any master-slave.

master only.

 

auto CHECKSUM CORRECTION support

Advantages:

Its own hardware interface allows to avoid all compatibility and driver problems;

Work through built-in 20 or 26 pin JTAG connector;

Full access to ECU memory at high speed of more than 100 KB/s;

Open files save;

Firmware checksum verification and recalculation.

Package

Toyota Lexus ECU Flasher adapter

Software